Millipore AFS-16D Reverse Osmosis Water Purifier

Product Description FEED WATER REQUIREMENTS
Minimum pressure and flowrate 1.5 bar (22 psi) at 120 LPH **
Maximum feed water pressure 3.0 bar (50 psi)
Conductivity < 2000 us/cm
Temperature 2 - 35C (35.6 - 95F)
pH 4 - 10
Fouling Index (SDI) LT OR = 5
Total chlorine . 1.0 ppm without PrePak
LT OR = 3 ppm with PrePak

ENVIRONMENTAL SPECIFICATIONS
Indoor Use Only
Storage Temperature 5C < T < 40C
Operating Temperature 5C < T < 40C
Relative Humidity Should not exceed 80% for temperatures below 31C
Should stay within 50% to 80% between 31C and 40C.
Altitude < 3000 metres
Installation Category II
Pollution Degree 2

PRODUCT WATER QUALITY AND PRODUCT WATER FLOWRATE SPECIFICATIONS
Ionic rejection Typ. - Min. 97 % - 94 %
Rejection of Particles > 99 %
Rejection of microorganisms > 99 %
Rejection of Organics > 99 % for MW > 100
Silica > 99 % rejection . 0.05 mg/L
Maximum Bacterial Content: LT OR = 10 CFU/ml
Resistivity: GT OR = 10 uOcm AT 25C
Produces Type I reagent water from tap water at a flow rate of 16L/hr.
Any used filter cartridges, if present, are included AS IS (not tested, not guaranteed).

---